Washer not draining in Tampa, 33619

Washer would not drain. Replaced the drain pump.

$99service call, credited to the repair

90 daysparts and labor warranty

8 to 4Monday to Friday

$125commercial service call

Repair request

Book a technician

URL

This field is for validation purposes and should be left unchanged.

Name(Required)

Email(Required)

Phone Number(Required)

Message(Required)

This field is hidden when viewing the form

Medium

This field is hidden when viewing the form

Source

This field is hidden when viewing the form

Campaign

What Type of Appliance(s) Do You Need Repaired?(Required)

Refrigerator / Freezer

Oven

Stove / Cooktop

Dryer

Washing Machine

Other

$99 service call, credited to the repair. $125 for commercial units. Or call (813) 822-5910, Mon to Fri, 8 AM to 4 PM.

Work orderAug 14, 2026

Area: Tampa, 33619
Unit: Washer
Symptom: Washer would not drain
Found: The drain pump had failed
Outcome: Replaced the drain pump

Report by Sam Ralin, owner and senior technician

A washer in the 33619 area was left full of water at the end of the cycle. The technician checked the drain path from the pump filter to the standpipe, then tested the pump itself. The drain pump had failed.

The drain pump was replaced.

What to check before calling

On a front loader, drain the water through the small hose behind the bottom panel and clean the pump filter.
Make sure the drain hose is not kinked behind the washer.
Check that the standpipe or laundry sink is not backed up.

If the filter is clean and the hose is clear, the pump is the usual cause.

More recent jobs

All job reports

Drain pump and hose under an LG top load washer

SarasotaOct 2026

LG top load washer showing an OE drain error in Sarasota

Unit: LG washer, WT1001CW
Symptom: Washer stopped with an OE error and would not drain
Found: The washer drained normally during the visit and the drain pump ran. The fault looked intermittent, a pump that fails under load
Outcome: Recommended a new drain pump as a preventive repair. The customer chose to wait and call back if the OE code returns

Burnt and scaled water inlet valve and dispenser assembly from a Maytag washer

Tampa, 33609Jun 2026

Maytag top load washer filling while turned off in Tampa

Unit: Maytag washer
Symptom: Water dripping into the washer drum even when the washer was off
Found: The hot and cold water inlet valves were leaking internally and not closing
Outcome: Replaced the water inlet valve and dispenser assembly

Whirlpool top load washer, model WTW4816FW2

South TampaApr 2026

Whirlpool top load washer banging on spin in South Tampa

Unit: Whirlpool washer, WTW4816FW2
Symptom: Very loud banging during the spin cycle, getting worse over time
Found: The suspension rods were worn out
Outcome: Replaced the suspension rods